System connections
Connecting other components
?Do not plug in the AC power cord until all other connections have been made.
?On each pair of input or output jacks, the jack marked R corresponds to the right channel, and the jack marked L to the left
channel. Refer to the ampliŢer�s instruction manual for further information on connections.
?Avoid bundling the audio connection cables with the power cord or speaker cables. Doing so may degrade sound reproduction.
?Insert the plugs and connectors securely. Remember that improper connection can result in noise, poor performance, or dam-
age to the equipment.
Improper
connection
Terminal protection caps are attached to the DIGITAL OUTPUT
terminals. Remove the cap for the terminal you wish to use when
connecting the DX-7222 to digital equipment. Replace the caps
Insert
if you are not using the DIGITAL OUTPUT terminals.
completely
ANALOGDIGITALDIGITALREMOTEOUTPUTOUTPUTOUTPUTCONTROL
OPTICAL 1OPTICAL 2COMPACT DISC PLAYER
LMODEL NO. DX-7222WARNINGAVIS
RATING: RISK OF ELECTRIC SHOCKDO NOT OPENRISQUE DE CHOC ELECTRIQUENE PAS OUVRIR
R
220-230V120V
VOLTAGE SELECTOR
3
Audio connection cableConnecting an Onkyo product
with connectors enables you
to use the System function.
4To AC outlet
cable
Optical Ţber cable
(not included)
122
LR
(REC)jackDIGITAL INDIGITAL IN
AmpliŢer without MD player, DAT, etc.AmpliŢer, Tuner ampliŢer
digital inputswith digital inputswith digital inputs
AConnection with the ampliŢer
Connect the DX-7222 to the CD jacks of your ampliŢer.
BConnection via the digital output terminal (DIGITAL
OUTPUT)
Connection to digital equipment, such as an MD recorder or
DAT.
Use an optical cable to connect this unit to the digital input
terminal of an MD recorder or DAT in order to make digital
recordings. The optical cable should have connectors which
Å¢t into the digital terminals.
CConnections for remote controlONKYO
When the DX-7222 is connected to an ampliŢer with the Onkyo
jack, pressing the CD operation button on the ampliŢer�s
remote controller enables you to operate the CD player.
Note:
DConnecting the AC power cord and turning the
?The upper and lower remote control jacks have the
power on
same function.
?Remote control operation is not possible when only the1. Insert the AC power cord into a wall outlet.
remote control cable is connected � the audio cables must2. Press the POWER ON/OFF button.
also be connected.
The display will light.
?An cable equipped with a 1/8" (3.5mm) diameter min-
Note:
iature two-conductor phone plug is included with the DX-
7222 and with every tuner, compact disc player or cassetteTo insert the AC power cord into an AC outlet on the rear panel of
tape deck with the symbol.another component, use the UNSWITCHED outlet.
6 |
ACEC
ONKYO
