Skin Detail CorrectionAdjusting Color in the Specified
Area
The DXC-D35/D35P/D35WSL/D35WSPL provides
an easy push-button function that designates an active
You can adjust the specified color using setup files.
skin tone area.
Perform the same procedure with the skin detail
correction to designate the target area .
1Turn the POWER switch on with holding down the
UP/ON button.
2Perform steps 1 and 2 in OChanging File Settings�
ON(page 73) and display advanced menu page 12 in
1
OFFthe most suitable file for shooting.
SET
2,3
SKIN DTL
1Set the SKIN DTL switch to ON.
The indication OSKIN AREA: ?0� appears in the
viewfinder.3Perform the procedure for the skin detail correction
to designate the area to which you apply color
2Press the SKIN DTL SET button.adjustment.
This causes the area detect cursor to be shown inWhile this procedure is being performed, the menu
the viewfinder (for 10 seconds).is not displayed.
3Place the area detect cursor on the target, then4When advanced menu page 12 appears, change the
Chapter 5 Adjustments and Settings
press the SKIN DTL SET button.value of the SKIN SAT or SKIN HUE to adjust
color in the area designated in step 3.
This designates the correction area, which is
indicated by a zebra pattern, and the indicationNote
OSKIN AREA: ?0� appears again. If the areaSet the SKIN DTL to 1.0 in basic menu page 2 if the
detect cursor disappears before designating theskin detail correction is unnecessary.
area, press the SKIN DTL SET button again to
display the cursor. (Return to step 2.)
4Press the UP/ON or DOWN/OFF button to change
the SKIN AREA value (�99 to +99)so that the
zebra pattern may be displayed in the target area.
Use basic menu page 2 to set the correction level
(see page 59).
You can also change color in the designated area
(see the following section).
Chapter 5 Adjustments and Settings93 |
ACEC
SONY
