Setting Up and Using
the E62i /E31i / E30i
9. Experiment by moving each of the Equalizer sliders up and down, carefully listening toENGLISH
the audible result on the audio signal. Bear in mind that the very lowest and highest
frequency areas may have little or no effect on some signals. Experiment further by
pressing in the ?12 dB switch(es) to deepen the effect of the Equalizer sliders, cutting and
boosting by as much as 12 dB instead of 6 dB. If there is significant low frequency noise
(rumble) in the signal, engage the HPF switch(es) as necessary. Press in the Cut Only
switch(es) if you want to use the Equalizer sliders only to cut frequencies without any
boost (bear in mind that, when the Cut Only switch is engaged, maximum boost for each
Equalizer slider is Oflat� and the center detented position of each Equalizer slider
represents a cut of -3 or -6 dB, depending upon the setting of the ?12 dB switch).
As you work with the various front panel controls, press the front panel Bypass switch(es)
in and out from time to time in order to compare the effect of the equalization curve you
are creating with the original input signal.
10. Once youOve created the frequency curve required for your particular application (see
the OAbout Equalization� section on the following pages for more information), an optional
locking security cover (available from your local Samson dealer) can be placed over the
front panel to make sure that your settings are not inadvertantly altered.
If you have followed all the steps above and are experiencing difficulties with any aspect
of setting up or using your E62i/ E31i/ E30i, you can call Samson Technical Support
(1-800-372-6766) between 9 AM and 5 PM EST, or contact your local distributor.
13 |
ACEC
SAMSON
