Guided Tour
1: Battery door release -Press
this latch gently upwards in order
to open the battery door and
¨access the controls contained
EarAmp
within. When closing the battery
1
door, swing it gently upwards until
you hear this latch click.
2: Stereo input connector -
ENGLISH
Using the included Y-cable (which
terminates at dual XLR plugs),
STEREO INPUTconnect incoming line-level signal
(normally from your mixerOs aux,
2
cue or line outputs) to the
SAMSON
IE80 MONITOR AMPLIFIEREarAmpa via this 6-pin OHirose�
connector. See page 9 in this
manual for more information.
3: Limiter level control
(trimpot) -Use the supplied
screwdriver to adjust this as
necessary. The EarAmpOs built-in
¨limiter circuitry is designed to
EarAmp
protect your ears against signal
6
2 CH-15dBONoverload. As the limiter level
8 control is turned clockwise, the
STEREOOFFOFF
MODE ATTEN. POWERlimiter threshold is reduced,
7
causing the limiting circuitry to
3
LIMITER LEVEL-Okick in� at lower input signal+
4BASSstrengths. As it is turned counter-
TREBLE9 clockwise, the limiter threshold is
5
increased, so that the limiting
circuitry only operates at relatively
high input signal strengths.
4. Bass control (trimpot) - Use
the supplied screwdriver to adjust
this as necessary. As the bass
control is turned counterclockwise,
bass response is reduced by up to
10 dB; as it is turned clockwise,
bass response is increased by up
to 10 dB. The bass control affects
frequencies at around 150 Hz.
5 |
ACEC
SAMSON
