Changing the light bulbs.. .
WARNING: Before removing a light shield for
light bulbs behind refrigerator and freezer con-
cleaning or for replacing the bulb,
either unplug refrigerator or dis- trol consoles:
connect electricity leading to re- 1 Pull control knob strarght off.
frigerator at the main power supply. 2. Pull bottom of control panel strarght out.
Shock and injury can occur if eiec- 3. Lift top of panel off supports
tricity remains connected. 4 Replace with a 40.watt appliance bulb.
5 Replace panel in reverse order.
Pull Off the Dial;
Out at the Bottom
Removing the base grille... rMetal Clips 7 ,
1. Open the doors.
2. Pull grille outwards as shown.
2 Push firmly to snap into place.
3. Do not remove Tech sheet fastened behind grille
3 Close the doors.
Ice cube trays.. .
If cubes are not used, they may shrink. The moving To remove ice:
cold air starts a slow evaporation. The longer cubes 1. Hold tray at both ends.
are stored, the smaller they get. 2. Slightly twist
l The ice maker will noi operate until the freezer is
Optional automatic ice maker.. .
cold enough to make ice. This can take overnight.
If you have the automatic ice maker accessory or l Because of new plumbing connections, the first
plan to add one later [Part No. ECKMF-61). there are a ice may be discolored or off-flavored. Discard the
few things you will want to know: first few batches of ice.
l The ON/OFF lever is a wire signal arm. l If ice is not berng made fast enough and more ice
Down,, .for making ice automatically; is needed, turn the Temperature control to a higher
Up...toshut off the ice maker. number. Wait a day and, if necessary, turn the Air
l Shake the bin occasionally to keep cubes sepa- Control to a higher number.
rated, and to obtain increased storage capacity.
l If you remove the ice bin, raise the signal arm to
l It is normal for ice crescents to be attached by a shut off the ice maker. When you return the bin.
corner. They will break apart easily. push it all the way in and lower the arm to the ON
On posrtion.
l If cubes are stored too long, they may develop an
off-flavor...like stale water, Throw them away. They
will be replaced. Cubes in the Ice bin can also
become smaller by evaporation.
0 Good water quality is important for good ice quality
It is not recommended that the ice maker be con-
nected to a softened water supply. Water softener
Signal
Lower Signal chemicals such as salt from a malfunctioning soft-
Arm to Start It. Maker. ener can damage the ice maker mold and lead to
l You will hear water running when ice maker is poor quality ice. If a softened water supply cannot
working. You?ll hear ice fall into the bin. Don?t let be avoided, then it is important that the water soft-
these sounds bother you. ener be well maintained and operating properly.
7 |
ACEC
WHIRLPOOL
