Install properly... Remove sales labels. . .
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet tastened under
the refrigerator at the front.
Clean it... m
Clean your refriger-
ator before using it.
1. Allow YZ inch (1.25 cm] space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
Level refrigerator-freezer...
Plug it in...
USE SCREWDRIVER 3-PRONG GROUNDING
TO ADJUST TYPE WALL RECEPTACLE\
FRONT ROLLER
VELLING SCREW
REFRIGERATOR 3- PRONG
POWER CORD GROUI NDING PLUG
RECOMMENDED GROUNDING METHOD
IGHT TO RAISE;
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
LEFl TO LOWER and properly grounded electrical supply is
1. Remove base grille (see page 8). required. It is recommended that a separate cir-
cuit sewing only this appliance be provided.
2. To raise front, turn screw in direction shown. Do not use an extension cord. Use a recepta-
3. To lower front, turn screw in the direction shown cle which cannot be turned off with a switch or
4. Check with level. pull chain. See individual electrical requirements
5. Replace base grille (see page 8). and grounding instruction sheet in your literature
package.
4 |
ACEC
WHIRLPOOL
