9. Plug cord into wall outlet and
return cold control to original
setting. Check to see that
4. Place pans of hot water inside the signal light glows. Return
freezer to hasten melting of food to the freezer.
frost. Leave door open. As
ice softens and melts, it con NOTE: Cleaning waxes, con-
be removed In large pieces. 6 Wash inside of freezer with a centrated detergents, bleaches
Direct air from on electric fan
into the freezer to speed solution of 2 tablespoons of and cleansers containing
baking soda to one quart of petroleum products should not
defrosting. warm water. Rinse and dry. be used to clean door gasket or
Wash the gasket strip around plastic parts of the freezer.
the door with worm, soapy
water. Rinse and dry.
Replacing
interior light
5 Remove drain cop from in-
side bottom of freezer. Re-
move the base grille by
opening the freezer door
and lifting up ontwo tabs
that extend through the grille
at either end. Pull grille for-
ward and lift off bottom Disconnect electric cord from
supports. outlet. Remove light shield by
pulling away from the side
wall. To replace, insert tabs in-
to opening in freezer side wall
and press. Replace bulb with no
larger than a 40.watt appliance
bulb. Reconnect freezer.
7. Wash outside of freezer with
worm water, using a mild
soap or mild detergent. Rinse
Unclip hose and and dry. Do not use an
allow defrost waterto drain abrasive or harsh cleanser.
through the hose into a flat Waxing is not recommended
pan. After defrosting and
cleaning, hook drain hose in 8. Clean condenser located
place and replace the base behind the base grille with a
grille and drain cap. stiff brush or with the dusting
attachment from your
vacuum cleaner.
4. |
ACEC
WHIRLPOOL
