6. Wind the shorter length of the cable counterclockwise
two turns, working from the front to the back side.
Then, slip the Cable Holdingthe pu Jig onto lley.
NOTE
Make sure that no part of the cable rides on the other.
7. Assemble the Scanner Drive Shaft Assy and install it
in the copier.
NOTE
When securing the Scanner Drive Shaft Assy, press it
against the optical frame.
8. Loop the side of the cable with one fixing bead around
the outer pulley for the 2nd/3rd iage anMirrorsd Carr
hook the fixing bead to the adjustable anchor.
The illustration shows the front side of the copier. The
same applies to the rear side.
9. Loop the side of the cable with two fixing beads
around the pulley on the frame and the inner pulley for
the 2nd/3rdirror Ms Carriand hoage ok the fixing bead
to the spring anchor.
The illustration shows the front side of the copier. The
same applies to the rear side.
10. Remove the Cable Holding Jigs.
11. Mount the Scanner Motor and timing belt and make the Scanner Motbelt aor timidjngus tment.
(For details, see "ADJUSTMENT.")
12. Mount the Scanner and perform theocus "F-Positioning of anner and 2nthe Scd/3rd rrorsMi
Carriage." (For details, see "ADJUSTMENT.")
D-40 |