EP790K230 ?y 10-11
TO START/STOP MASSAGE ACTIONPROGRAMMED MASSAGE
Before using, first read all the instructions including the warnings and safety precautions as well as the
section on programmed and manual massage.First read, and familiarize yourself with, the safety precautions.
<BEGINNING OPERATION>
1. To operate the massager, press the �start/reset� button.<HOW TO PRESET THE MASSAGE HEAD POSITION>
1. Press the �start/reset� button with cover slide down fully.
Check to be sure the operation indicator lamp is lit.
2. Set the massage heads adjustment switch to position �7�.yyyyyyyyyyyyyyyyyyyyy
Operation indicatorThen adjust the massage heads to your shoulders while moving the adjustment switch.yyyyyyy
lamp
The massage heads operation lamp flashes while moving the massage heads.
3. You can adjust the massage heads position while massaging.yyyyyyyyyyyyyyyyy
NOTE :When you find your favourite position, memorize the number which is printed near the switch.
2. If you wish to stop the massage immediately, press the �stop� button.
The massage heads will stop where they are.
Check to be sure the operation indicator goes out. To restart massage press �start/reset� button.
<HOW TO SELECT THE PROGRAMMED MASSAGE COURSE>
1. If you wish to massage your whole back, press .
2. If you wish to massage your neck and shoulders mainly, press .
3. After final use, press the �start/reset� button.
3. If you wish to massage your lower back, press .
The massage heads will go up, spread out and stop in the restore position. With the heads in this
Massage will operate automatically for 15 minutes after pressing the button.
position you can sit comfortably, using the massager as a regular chair. NOTE : Check to be sure the course indicator lamp is lit.
Be sure to store the controller in the pocket on the side of the left arm rest when not in use.
If you wish to change the massage course, press any button you want.
Operation indicatorYou may change the massage course at any time during operation without harm
lampYour new instructions will override any previous ones.
4. Do you want programmed or manual operation?
If you wish to select a programmed massage, slide the cover down fully and press buttons.
If you wish to select the manual massage, slide the cover upwards fully and press buttons.
With cover slid up fully
<whole back><neck shoulder><lower back>
<GENTLE MODE FOR PEOPLE WHO FEEL MASSAGE IS TOO STRONG>
With cover slid down fullyPress (gentle mode button) button.
Gentle mode indicator lamp is lit.
The entire massage changes to a less intense, more gentle massage.
(Course contents do not change)
Gentle mode can be selected even in the middle of a programmed massage course.
Pressing the gentle mode button again will cancel gentle mode.
Automatic timer for massage loungerAfter the automatic course has finished, the massage heads will automatically
To prevent excessive massaging there is a built-in timer which, after approx. 15 minutes of operation, will move to the �restore� position and stop.
automatically return the massage heads to the �restore� position and stop their motion.
To perform massage again, press the �start/reset� button on the controller again.
Turning on the operation switch while the massage heads are moving to the �restore� position will reset
the time for another 15 minutes (approximately).
If the programmed massage button is pushed, the unit will stop after finishing the program.
1011 |
ACEC
PANASONIC
