DESCRIPTION OF THE APPLIANCEINSTALLATION
Important
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCEIt must be possible to disconnect the appliance from
A
THAT HAS A LOCK OR CATCH ON THE DOOR,the mains power supply; the plug must therefore be
YOU MUST ENSURE THAT IT IS MADEeasily accessible after installation.
BUNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
J
Depending upon the position which you choose for
C
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
Ion ODoor reversal directions� paragraph.
H
D
Positioning
G
This appliance is designed to operate in ambient
10-
1-3-43-3-3-3-10-10-10-temperatures between 10!C (50!F) and 32!C (90!F).
F
It should be located in a dry atmosphere, out of100 mm
direct sunlight and away from extreme temperature
e.g. not next to a boiler or radiator, or in a very cold
room e.g. an outhouse, where the temperatures may
AB
E
fall below 10!C (50!F). If these temperatures are
exceeded i.e. colder or warmer, then the appliance
may not operate correctly.
10 mm10 mm
You should also ensure that air can circulate freely
NP002
around the back and the top of the cabinet. There
must also be at least 100 mm (4�) distance between
the top of the cabinet and any overhanging kitchen
furniture (A). Ideally, the appliance should not be
positioned beneath overhanging furniture (B).
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
A - Thermostat control for fridge and freezer compartmentsclose to the wall but must not touch it. DO NOT
install in places with restricted ventilation.
B - Dairy compartment
Adjust the level of the appliance by screwing out the
C - Can storage shelf
adjustable foot, or feet, at the bottom of the cabinet
D - Bottle storage shelf
using your fingers.
E - Compartments for frozen food storage
D200
F - Compartment for freezing fresh foods
G - Pizza box compartment
H - Salad drawersRear spacers
I - Glass shelf
In the bag with the documentation, there are two
J - Wire shelves spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
PR153
417 |
ACEC
ZANUSSI
