aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
4. Sample mode
Selecting a sample
4. Sample mode
Sample00.(ll)...99.(ll)
In this mode you can record a new sample, or modify or delete
00.S...49.S
samples.
Press the SAMPLE mode key to enter sample mode.
Use the cursor keys to make the parameter select LED indicate
Sample. Rotate the dial to select one of the 150 samples from
O00.� (displayed as O00.ll� if sliced) to O99.� (displayed as O99.r�
Sample mode
if sliced) or from O00.S� to O49.S.� Samples from O00.� to O99.�
Sampling area = total 95 secondsare monaural samples, and will be displayed as O00.ll� if sliced.
Samples from O00.S� to O49.S� are stereo samples.
Monaural samples 00....99.
(Slice samples displayed as 00.l l)Edit in It is not possible to select a sample that has not been
Sample mode
saved. If no samples exists in the ES-1Os sampling area,
Normalize, the display will indicate O- -.-�
Stereo samples 00.S...49.S
Truncate,
Time Slice,
WriteStart, End, Playing a sample
Fadeout
If you press the Play/Pause key or a sample part key 1N7B, the
sample will be played back. A slice sample can also be played
by pressing the Slice Sample part key.
In the case of a slice sample, the step keys will light to indicate
Assign to each part
Edit in Pattern modesteps where there is sound, and you can press these keys to
Pitch/Speed, Filter, Level, Panplay the sample sound at the corresponding location.
Even if the sample has been sliced, it will be played as a
single sample if you press a sample parN 7B. t key 1
Recording a sample
The ES-1 lets you connect an audio device (e.g., CD or MD) orModifying a sample
mic and record various sounds to use as samples. A maximum
The knobs and keys of the Part Edit section and Effect section
of 95 seconds can be sampled and kept in internal memory.
can be used to modify the sound while you are in Sample mode
If the factory preloaded samples are rewritten or eras well. (ased,p.33 OPattern mode�)
they cannot be restored to their original state. If you do
The knobs and key on/off status in Sample mode is not
not want to lose the factory preloaded samples, purchase4. Sample mode
saved when you perform the Write operation.
a SmartMedia card and perform the Save operation
(p.55) to make a backup.The Roll key has no effect in Sample mode.
If you run out of memory while sampling, sampling will
stop automatically. Before you start sampling, use the
Sample mode Memory function (p.32) to check the re-
maining amount of sampling time.
Stereo samples occupy twice as much memory. The avail-
able time for sampling will be one half of the time dis-
played in Memory (p.32).
Connect an audio device (e.g., CD or MD) or mic to the Audio
In jack. If you connect a line-level device such as a CD or MD,
set the MIC/LINE select switch to the LINE position. If you
connect a mic, set the switch to the MIC position.
For details on the sampling procedure, refer to 3. Basic opera-
tion (Quick Start), p.23 ORecording a sample.�
27 |
ACEC
KORG
