IMPORTANT NOTES
?Operate controls and switches as?Avoid installing this unit in places
described in the manual.exposed to direct sunlight or close to
?Before turning on the power, makeheat radiating appliances such as
certain that the connecting cords andelectric heaters, on top of other stereo
power cord are properly installed.equipment that radiates heat, places
?Store your CDs in a cool area to avoidlacking ventilation or dusty areas,
damage from heat.places subject to constant vibration
?When moving the set, be sure to firstand/or humid or moist areas.
disconnect the power cord and?Do not attempt to clean this unit with
remove cords connected to otherchemical solvents as this might
equipment.damage the finish. Use a clean dry
cloth.
CLASS 1 LASER PRODUCT
CAUTION
CLASS 1 LASER PRODUCTINVISIBLE LASER RADIATION
APPAREIL � LASER DE CLASSE 1WHEN OPEN AND INTERLOCKS
PRODUCTO LASER DE CLASE 1DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a low power Laser Device.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
?Reorient or relocate the receiving antenna.
?Increase the separation between the equipment and receiver.
?Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
?Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference
that may cause undesired operation.
3
ES27_ib_drafts.p6519/3/2002, 16:093 |
ACEC
OTHERS
