1@&4@@@@64"�?´
You can always connect your shaveramong many other shaving aids (gel,* Do not pour water over the
Do not place fingers on the On/Off
to the self-cleaning recharger or thesoap, cream, etc.). Do not put a thickwater feed line in the tank.switch during use.
adaptor to maintain full battery ca-layer of shaving foam as it may af-This may cause the cleaning
This may cause the shaver to stop
pacity. This shaver cannot be over-during use or change it to thefect shaver�s performance. If theliquid to spill.
charged.shaving head is clogged with foam,3. Firmly shut the water tank cap
�sonic� vibration cleaning mode.
Before travelling, charge it fully for 1Place your finger on the finger restsimply rinse it under running water.and attach the tank to the self-
hour if you will not be taking the adap-during use.cleaning recharger (see fig. 13).
tor with you.Using the trimmer4. Peel off the seals from the new
Hold the shaver at a right angle (90�)(see fig. 9)detergent cartridge (two seals)
Charging without self-to your skin (see fig. 6). Start outSlide the trimmer handle up to open(see fig. 14).
shaving by applying gentle pressure
cleaning rechargerthe trimmer.� Hold the detergent cartridge
to your face. Stretch your skin withPlace the trimmer at a right angle tohorizontally. (The detergent
Connect the power cord to the
your free hand and move the shaveryour skin and move it downward tomay spill if tilted excessively.)
shaver, and plug the adaptor to an
back and forth in the direction of yourtrim sideburns.5. Attach the detergent cartridge to
AC outlet (see fig. 5). The shaver will
beard. You may gently increase thethe self-cleaning recharger (see
be adjusted automatically to voltages
amount of pressure as your skin be-Cleaning your shaverfig. 15).
between 100-240V AC.
comes accustomed to this shaver.
� Do not use any solution other
In some areas, a special plug adap-
Applying excessive pressure does1 Cleaning with the self-cleaning
tor may be required.rechargerthan the Panasonic Shaver
not provide a closer shave.
self-cleaning recharger special
Pivot action selectorPreparing the self-cleaningdetergent.
(see fig. 7)recharger� Be sure to change the deter-
Using your shaver
Use the pivot action selector togent cartridge and the clean-
Warning � Do not wash or apply
Caution � The system outer foil ischoose the shaving mode, �soft�ing liquid inside the water tank
water to the adaptor or self-clean-
very thin and can be damaged if(soft) and �lock� (lock) based on yoursimultaneously.
ing recharger.
handled improperly. Before eachshaving preference.Adding water, or changing just
Failure to observe this may cause
use, always check the foil for dam-The pivot action can be changedthe detergent cartridge or the
electric shock or result in short
age. To avoid personal injury, dowhether the switch is turned on orwater, will result in deteriorated
circuits.
not use if the foil or other parts ofoff.cleaning functions.
the shaving head are damaged.� When the self-cleaning
System outer foil1. Detach the shaver and the appli-
(see fig. 8)ance plug from the self-cleaningrecharger is operated, the con-Push the On/Off switch to turn the
centrated detergent inside the
System outer foil has a slit blade (a)recharger.shaver on.
between 2 foils (b). They move up2. Fill the water tank with water.cartridge will be diluted and the
If you push and hold the On/Offand down independently to follow the1) Remove the water tank fromwater inside the tank will
switch for more than 2 seconds, itcontours of your face.the self-cleaning rechargerbecome a cleaning liquid.
will activate the turbo mode forThe slit blade catches and cuts(see fig. 10-1).Cleaning your shaver
�sonic� vibration cleaning.longer and lying hairs easily.2) Open the water tank cap (see1. Insert the appliance plug into the
(see �Cleaning your shaver with-fig. 10-2).self-cleaning recharger socket
out the self-cleaning recharger�)For wet shaving3) Wash away the old cleaning(see fig. 16-1).
Shaving with �sonic� vibration mayliquid inside the water tank and
Put a thin layer of shaving foam on2. Firmly insert the adaptor into the
damage your skin. Please turn itrinse (see fig. 11).
your face which works as a lubricant.AC outlet (see fig. 16-2).
off and on again to deactivate the4) Pour tap water up until the
Shaving foam is the most suitable
turbo mode.feed water line (see fig. 12).
1011
1011 |
ACEC
PANASONIC
