53963-gb.fm5 Page 18 Tuesday, March 13, 2001 7:28 PM
ELECTRICAL CONNECTION
? Make sure the appliances are installed ? The appliance must be connected to the
and connected to the electricity supply electrby icity supply by means of an all-pole
a qualified technician in accordance with disconnect switch with minimum contact
the manufacturer?s instructions and in gap of 3 mm.
compliance with local regulations.
? The appliances must be earthed by law.
? The installer is responsible for the correct ? Do not use multiple plug adapters or
electrical connection of the appliances
extension leads.
and the observance of the relative safety
? After the appliances have been installed,
regulations.
the electrical components must be
inaccessible.
Connecting the oven to the power supply
? Make sure that the voltage shown on the rating
plate is the same as the power supply voltage in
your home. The rating plate is on the front edge of
the oven cavity (visible with oven door open).
? Use a type H05RR-F power cord (minimum
length 800 mm).
? Warning: All the oven?s components operate at
230-240 V. When using a 400 V connection,
make sure that the voltage reaching the oven is
230-240 V, as illustrated in the side table.
Conductors X
Connection
number
H05 RR-F 3X4 mm2
1N+ ~
H05 RR-F 4X2.5 mm2
2N+ ~
H05 RR-F 4X2.5 mm2
3+ ~
H05 RR-F 5X1.5 mm2
3N+ ~
Interconnecting cooktop and oven
? Before connecting the oven to the power supply,
check that the cooktop is among the ones listed in
the cooktop/oven pairing product sheet.
Connect the 3 pole and 4 pole connectors to the
respective connectors on the oven.
? The 3 pole connectors (H) is located at the rear
right hand side of the control panel, the 4 pole
connector (J) is located at the top of the oven in the
left hand corner (see figure).
? Connect the yellow/green striped earth wire ()
(K) from the cooktop to the screw located near the
3 pole connector.
WARNING: DO NOT CONNECT TO THE
POWER SUPPLY BEFORE YOU HAVE
FINISHED CONNECTING THE OVEN AND
COOKTOP.
? Mount the oven in the kitchen unit.
Make sure the power cord is not trapped.
18 |