Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Gurde label and other
Inside labels before using the refrigerator. Any glue
left can be taken off with rubbing alcohol
Do not remove the label giving operating in-
structions for the Refrigerator and Freezer Con-
trols or the Tech Sheet fastened under the
refrigerator at the front.
Clean it.. .
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2 Allow at least an inch (2.5cm) between the refrig-
erator condenser and the wall.
3. Allow % inch (1.25 cm) on each side of the re- Clean your refrigerator before using it. See clean-
frigerator for ease of installation.
ing instructions on page 8.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
, .- ., , _m... . 3 , .
PI ,ug it in...
Level refrigerator-freezer... J-prong
grounding type
Use Screwdriver wall receptacle :,
to Adjust
3-prong
grounding plug
Lefl to Lower
t
1 To raise front, turn each screw to the rrght Refrigerator
2. To lower front, turn each screw to the left Power Cord
3 Check with level
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz.. AC only, 15 ampere fused and
grounded electrical supply is required. It is recom-
mended that a separate circuit serving only this ap-
pliance be provided,
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package. |
ACEC
WHIRLPOOL
