BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check6.Electrical connection
a.Cut and remove the shrink-wrap.? Electrical connections must be carried out by a
b.Remove the top protection and the protective qualified technician in compliance with the
corners.manufacturer?s instructions and the current
c. Remove the bottom protection by tilting and standard safety regulations.
turning the appliance on one rear bottom corner.? The technical data (voltage, power and fuses) are
2.Remove the transport bracketgiven on the rating plate on the rear of the
? The appliance is fitted with transport screws and appliance.
a transport bracket to prevent damage during
transport. Before using the washing machine ? The appliance must be connected exclusively by
you must remove the transport bracket (see means of a socket with an earth connection in
?Installation/Remove the transport bracket?).accordance with current regulations. The
appliance must be earthed by law. The
Do not forget to screw back 4 screws to the rear manufacturer declines all liability for damage to
panel by which was fixed the transport bracket - to persons or property deriving directly or
avoid noisy and vibration of the machine.
3.Install the washing machineindirectly from failure to observe the directions.
? Place the appliance on a flat and stable floor ? Do not use extension leads or multi sockets.
surface.? Before any maintenance on the washing machine
? Adjust the feet to ensure that the machine disconnect it from the mains supply.
is stable and level (see ?Installation/Adjust ? Access to the mains plug or to disconnection
the feet?).from the mains supply via a double-pole switch
4.Water supplymust be ensured at all times following the
? Connect the water supply inlet hose in installation.
accordance with the regulations of your local
water company (see ?Installation/Connect the ? Do not operate the washing machine if it has
water inlet hose?).been damaged during transport. Inform the
? Water supply: Cold water only After-Sales Service.
? Mains cable replacement is only to be carried out
? Tap: 3/4? threaded hose connectionby After-Sales Service.
? Pressure:100-1000 kPa (1-10 bar).
?For Great Britain & Ireland only: ? The appliance must be connected to an effective
? Water inlet: hot and cold fill. The warm water earthing installation, in compliance with the
inlet temperature must not exceed 60° C.?regulations in force. In particular, appliances installed
in premises containing a shower or a bath must be
5.Drain hoseprotected by a differential residual current device of
? Connect the drain hose to the siphon or hook it
over the edge of a sink with the ?U? bend (see at least 30 mA. Earthing the appliance is obligatory
?Installation/Connect the water drain hose?).under the law. The manufacturer declines all liability
? If the washing machine is connected to a built-in for damage to persons or property deriving either
directly or indirectly from failure to observe the
drainage system, ensure the latter is equipped directions above.
with a vent to avoid simultaneous loading and
draining of water (siphoning effect).? The washing machine may only be used in the
household for the prescribed uses.
Dimensions:
Width:400 mm
Height:900 mm
Depth:600 mm
18 |
ACEC
LADEN
