&8??ó �?´
Inserting/replacing batteriesFitting the Blood Pressure Monitor
1. Slide off the Battery Cover1. Attaching the cuff to the upperPositioning on the Upper Left Arm+
from the housing.�arm.
�Make sure the cuff is wrapped so
2. Insert four 1.5 V batteriesthat it is in contact with the skin.
(R6/AA), ensuring correct1�
polarity.+Measurements may be taken
from either the left or right
2arm. However, please take3
3. Close the Battery Cover.
measurements using the same�Position so that
arm each time, because therethe tube extends in
is said to be a blood pressureline with the little finger
on the palm side.
difference of approx. 10 mmHg
between the left and right.
Positioning on the
Upper Right Arm
Batteries must be replaced when ...
�The Replace batteries symbol appears on the display.
�You press the ON/OFF/Start Button and the display screen
2. Fasten firmly, but not too tight.goes blank after all displays have come on.Wrap the cuff around
the arm 2 to 3 cm
�You press the ON/OFF/Start Button and nothing is displayed on the
�Optimally, there should be enough(25/32" to 1-3/16")
screen.above the elbow.
room to insert one finger between
Note:
the cuff and arm.
�New batteries contain enough power for about 200 measurements.
�Make sure your sleeve does not
�If you do not use the unit for a long time, we recommend to remove
get in the cuff.
batteries from the main unit to avoid damage by liquid leakage.
�Firmly attach using the hook-and-
�Low temperature conditions can cause battery life to be shortened.
loop tape.
CAUTION:
Do not throw batteries into a fire. Doing so may result in an accident or
explosion.
910 |
ACEC
PANASONIC
