EY6535(EU).book 8 k 2376767
Using Keyless drill chuck Using Quick change chuck
(EY9X003E)(EY9HX110E)
This Quick change chuck is
*EY6535GQWA does not include keyless drill chuck
designed to be used with Pana-
CAUTION: ? Use keyless drill chuck ONLY INsonic EY6535.
DRILL DRIVER MODE of EY6535.Top collar : To insert or to
This chuck is not designed to beremove bit
used in IMPACT MODE. It can beBottom collar : To attach or to
Top collar
damaged and its life will bedetach Quick
reduced. change chuckBottom collar
Use 6.35 mm (1/4") hexagonal bits.
To ensure proper securement of the bit, use only
hexagonal bits with 9.25 mm (3/8") detent. (Fig. 7)
? Moreover, the chuck and its metal
parts, such as the push button,CAUTION: Make sure the work environment is
front parts, and bit may becomesafe. When retracting bit from work
very hot. To prevent skin burns,material, Quick change chuck may
use work gloves and/or allowdetach if subjected to 50kg or more
heated parts to cool down beforeof pull force. Detachment will be sud-
handling.den. Use care and avoid excessive
? Make sure the work environment isforce when retracting bit from work
safe. When retracting drill frommaterial.
work material, Keyless drill chuck1. Attaching Quick change chuck
may detach if subjected to 100kgAttach the Quick change chuck by pulling the
or more of pull force. Detachmentbottom collar forward and sliding the female
will be sudden. Use care and avoiddetent on the bottom of the chuck to the
excessive force when retractingsquare drive on the body.
drill from work material.Release the bottom collar to make sure the
1. Attaching Keyless drill chuck (Fig. 2)Quick change chuck is firmly connected to the
Attach the chuck by sliding the female detentbody.
2. Inserting the bit (Fig. 8)
on the bottom of the chuck to the square drive
on the body.Pull the top collar of the Quick change chuck
forward, then insert the bit.
Make sure the chuck is firmly connected to theRelease the top collar to make sure the bit is
body.
firmly connected to the chuck.
2. Inserting the bit (Fig. 3)3. Removing the bit (Fig. 9)
Insert the bit, and turn the lock collar clock-
Pull the top collar of the Quick change chuck
wise(looking from the front) holding the sleeveforward, then pull the bit.
until jaws close firmly.CAUTION: lmpact mechanism creates heat.
3. Removing the bit (Fig. 4)Square drive and accessory may
Turn the lock collar counterclockwise (lookingbecome very hot and may cause skin
from the front).burns. To prevent skin burns, use
Then remove the bit.work gloves and/or allow heated
CAUTION: If the drill bit becomes too tight to
parts to cool down before handling.
remove, hold two lock collars with4. Detaching Quick change chuck
pipe wrenches and turn them inPull the bottom collar of the Quick change
opposite directions. (Fig. 5)chuck forward to detach it.
4. Detaching Keyless drill chuck (Fig. 6)
To detach the chuck, PUSH the button toAttaching or removing battery
release the chuck from the square drive.
pack
CAUTION: Drill bit blade is sharp. Make sure to
remove the drill bit before you set1. To connect the battery pack:
Insert the battery pack. It snaps into place to
and detach the keyless drill chuck.indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides of the bat-
tery pack. Slide the battery pack out of the tool
body.
? 8 ? |
ACEC
PANASONIC
