Battery packtime. (Max. charging ti-me is ap
prox. 90 minutes).
If a fully charged battery pack is
To AC inserted into the charger again,
outletthe charging lamp may light up
and then flash slowly. A-fter sev
eral minutes, the charging lamp
may flash quickly to indicate the
charging is completed.
6. If the charging lamp does not light
Battery immediately after the charger is
chargerplugged in, or if after the standard
charging time the lamp does not go
3. During charging, the charging lamp off, consult an authorized dealer.
will be lit.
When charging is completed, anNote: When charging a cool battery
internal electronic swit-ch will aupack (below 15?C (41?F) in a
tomatically be triggered to prevent warm place, leave the battery
overcharging.pack at the place and wait for
Charging will not start if the batterym ore than one hour to warm
pack is warm (for example, immedi-up the battery to the level of
ately after heavy-duty operation).the ambient temperature.
The orange standby lamp will be (Battery pack may not be fully
lit until the battery cools down. charged.)
Charging will then begin -automa ti Cool down the charger when
cally.charging more than tw-o bat
4. When charging is completed, the tery packs consecutively.
Do not insert your fingers into
charging lamp will start flashing rapidly.contact hole, when holding
5. When in any of the conditions that charger or any other- occa
battery pack is too cool, -or the batsions.
tery pack has not been used for a CAUTION: Do not use power source
long time, the charging lamp starts
flashing slowly to indicate protective from an engine generator.
Do not cover vent holes
charging. Protective charging takes on the charger and the
longer to fully charge the battery
pack, than the standard charging battery pack.
.LAMPINDICATIONS
Charger is plugged into a wall outlet.
FlashingReady to charge.
Now charging
Lit
Charging is completed.
Flashing quickly
Protective charging
Flashing slowly
Battery pack is warm. Charging will begin
when temperature of battery pack drops.
Lit
Charging is not possible. Clogged with
Flashingdust or malfunction of the battery pack.
- 9 - |
ACEC
PANASONIC
