a. pins on plug of extension cord are 18) Avoid dangerous environment. Do not
the same number, size and shape use charger in damp or wet locations.
as those of plug on charger.19) The charger is designed to operate
b. extension cord is properly wired on standard household electrical
and in good electrical condition.power only. Do not attempt to use it
c. wire size is large enough for ampere on any other voltage!
rating of charger as specified below.0) Do not abuse cord. Never carry charger
RECOMMENDED MINIMUM AWG SIZE OFby cord or yank it to disconnect from
EXTENSION CORDS FORoutlet. Keep cord away from heat, oil
BATTERY CHARGERSand sharp edges.
AC Input Rating. AmperesAWG Size of Cord1) Charge the battery pack in a well ven-
Equal to or But less Length of Cord, tilated place, do not cover the charger
greater thanthanFeetand battery pack with a cloth, etc., while
5 50 100 150charging.
018 18 18 16) Use of an attachment not recommend-
8) Do not operate charger with damaged ed may result in a risk of fire, electric
shock, or personal injury.
cord or plug-replace them immediately.
3) Do not short the battery pack. A
9) Do not operate charger if it has receiv-
ed a sharp blow, been dropped, or battery short can cause a large current
flow, over heating and create the risk
otherwise damaged in any way; take it
to a qualified service personnel.of fire or personal injury.
4) NOTE: If the supply cord of this appli-
10) Do not disassemble charger; take it
ance is damaged, it must only be
to a qualified service personnel when replaced by a repair shop authorized
service or repair is required. Incorrect
by the manufacturer, because special
reassembly may result in a risk of purpose tools are required.
electric shock or fire.
5) TO REDUCE THE RISK OF ELEC-
11) To reduce the risk of electric shock,
TRIC SHOCK, THIS APPLIANCE HAS
unplug charger from outlet before A POLARIZED PLUG (ONE BLADE IS
attempting any maintenance or clean-
WIDER THAN THE OTHER).
ing.This plug will fit in a polarized outlet
1) The charger and battery pack are only one way. If the plug does not fit
specifically designed to work together. fully in the outlet, reverse the plug. If
Do not attempt to charge any other it still does not fit, contact a qualified
cordless tool or battery pack with this electrician to install the proper outlet.
charger.Do not change the plug in any way.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the V. ASSEMBLY
battery pack housing.
15) Do not store the tool and battery pack Attaching or Removing Bit
in locations where the temperature NOTE:
may reach or exceed 50°C (1°F) ? When attaching or removing a bit,
(such as a metal tool shed, or a car disconnect battery pack from tool or
in the summer), which can lead to
place the switch in the center position
deterioration of the storage battery.(switch lock).
16) Do not charge battery pack when the
temperature is BELOW 0°C (3°F) 1. Hold the collar of quick connect chuck
and pull it out from the driver.
or ABOVE 40C (104F). This is very
important in order to maintain optimal . Insert the bit into the chuck. Release
condition of the battery pack.the collar.
17) Do not incinerate the battery pack. It 3. The collar will return to its original
can explode in a fire.position when it is released.
- 6 -
EY7542(UL).indb 62007/07/25 11:33:46 |
ACEC
PANASONIC
