132994030GB.qxd 5-04-2002 16:56 Pagina 72
8. Start the programme13. At the end of the programme
Depress START/PAUSE-button, the correspondingThe machine stops automatically.
pilot light stops flashing. The door light andIf the anti-crease option has been selected, the
WASHING light illuminate.END light and door locked light remain lit to indicate
that the water must be emptied out before opening
the door.
To do this turn the programme selector dial to OO�
and then to programme (drain) or (spin).
Select the required spin speed by means of the
relevant dial.
The door can only be opened after the door light has
gone out.
Switch the machine off by turning the programme
If you have selected the DELAY START, the machineselector dial to OO�.
starts its hourly countdown.
Remove the laundry from the drum and carefully
9. Altering a programmecheck that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
You can alter the programme before it starts.wash (e.g. shrinking) or their colour running into a
When the programme has started, you can onlyload of whites.
reset it by turning the programme selector dial to OIf you do not intend to carry out another wash, close
and then you can select the new programme.the water tap.
Start it by depressing the START/PAUSE button.Leave the door open to prevent the formation of
mildew and unpleasant smells.ENGLISH
10. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
11. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running.
Now you can select a new programme.
12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
The door can be opened when the door locked light
has gone out.
If the door does not open, this means that the water
temperature is above 55!C, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to OO�. After about 2
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress
START/PAUSE to restart it.
72 |
ACEC
ZANUSSI
