Door reversibility
Unplug the appliance before performing the Fig. 3E
following operations:C
Carefully lay the appliance on its back.A
Remove the foot (A-Fig. 3).D
Remove the hinge (C) by unscrewing the screws (B).
Remove the stop catch (E) by unscrewing the screws (D).
Slide the door out of the upper hinge.
Remove the upper hinge and Ţt on the opposite side B
(Fig. 4).D473
Reassemble the door, inserting the upper hinge pin
into the bushing on the door.
Unscrew the left foor and reŢt on the opposite side.Fig. 4
Fit the stop catch (E) on the opposite side.
Fit the hinge (C) and foot (A) on the opposite side.
Change the position of the handle (Fig. 5).
The holes that are not used are to be masked with the
plastic plugs removed.
AttentionD185
After completion of the door reversibility operation,
verify that the door gasket is adherent to the cabinet.
If the ambient temperature is cold (i.e. in Winter), the Fig. 5
gasket may not Ţt perfectly to the cabinet. In that
case, wait for the natural Ţtting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can var?y6% of the r by ated voltage.PR184
For operation with different voltages, a suitably sized
auto-transformer must be used.
TECHNICAL SPECIFICATIONGB
The technical data is indicated in the rating plate on the left side inside the appliance.
6 |
ACEC
CORBERO
