Installation
Unpacking7. Plug all the holes with the plugs which you will
find in the envelope containing the instruction
booklet.
All transit bolts and packing must be removed
ENGLISH
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
2. Lay the machine on its back, taking care not to
out. Never place cardboard, wood or similar
squash the hoses. This can be avoided by
materials under the machine to compensate for any
placing one of the corner packing pieces between
unevenness in the floor.
the machine and the floor.
3. Remove the polystyrene block(s) from the bottom
of the machine. Unscrew and remove the four
feet. Release the two plastic bags.
Water inlet
Connect the water inlet hose supplied with the
4. Very carefully slide out the left polythene bag,appliance to a tap with a 3/4" thread.
removing it towards the right and then downwards.Do not use already employed inlet hoses.
5. Very carefully slide out the right polythene bag, The other end of the inlet hose which connects to the
removing it towards the left and then upwards. machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
6. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.
5 |
ACEC
ZANUSSI
