Maintenance
1. Bodywork3. Cleaning of the drainage area
Clean the outside of the machine with warm water and aThe drainage area must be cleaned if the pump has
neutral, non-abrasive household detergent. Rinse withbeen blocked with objects such as buttons, safety pins,
clean water and dry with a soft cloth.coins, etc. , or if lint has built up because clothes that
generate lint have been washed at high temperatures.
Important: do not use methylated spirits, solvents orENGLISH
similar products to clean the bodywork.
Y Pull out the plug from the power socket.
Y If necessary, wait until the water has cooled down.
2. Detergent dispenser drawerY Open the drainage area door.
Y Place a bowl to collect the water.
After a while, detergents and fabric softeners leaveY Release the emergency emptying hose, place it in the
deposits in the drawer.
bowl and remove its cap, when the bowl is full put the
Clean the drawer from time to time by rinsing it under acap back on the emergency emptying hose.
running tap. To remove the drawer from the machine,Y Empty the bowl. Repeat the procedure until you have
press the button in the rear left-hand corner.
completely emptied the washing machine.
To facilitate cleaning, the top part of the additive
compartments can be removed.
P1114P1115
R0072C0073
Detergent can also accumulate inside the drawer recess:Y To continue, unscrew the lid of the diaphragm by
clean it with an old toothbrush. Refit the drawer afterturning it counter clockwise and pull it out.
Y Remove the objects such as buttons, coins and the lint
cleaning.that has been accumulated in the area of the pump
impeller by rotating it.
Y Screw the lid of the diaphragm clockwise, be sure is
completely tighten.
Y Replace the emergency emptying hose in its initial
position and close the drainage area door.
P1116P1117
11 |
ACEC
ZANUSSI
