132992820GB.qxd 23/06/2003 18:41 Pagina 76 (Nero/Process Black pellicola)
programme has been erased by means of the
SKIP/RESET button.
Important!
The first time you use the washing machine, when
you switch it on, it may display a blinking zero and
give an audible warning signal. This is due to the fact
that the washing machine has performed a washing
cycle during the manufacturer?s inspection tests,
and this cycle has not been erased after its
completion.
Delay start, a time value indicated in hours and
selected by means of the relevant button.9 START/PAUSE button
This button has three functions:
Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of
button 11, the countdown will begin and will be
shown on the display.
Pause: when you press this button again, the
programme in progress is interrupted. The light
The delay time is displayed for 3 seconds, then the
above the button will start flashing. To restart theENGLISHduration of the selected programme reappears.
programme, press the button again.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time valueWhen you PAUSE the cycle, the DOOR LOCKED
decreases by one unit every hour.light goes out, and it becomes possible to open
You can delay the start of the selected programmethe door, provided
by up to 24 hours in one hour intervals. the washing machine is not in the heating phase;
An incorrect option selection has been made: the level of the water is not high;
this is indicated by the message Err when a the drum is not turning.
function incompatible with the current programmeImportant! You must set the washing machine to
is selected.PAUSE before you make any change in the
programme in progress.
Draining of water and spinning after the
completion of programmes with the NIGHT CYCLE
option.
10 SKIP/RESET button
(SPECIALS/ANNULL.)
This button performs two functions:
- Clears the memory
The incorrect selection is also indicated by an- Selects special programmes
audible warning signal.
At the end of every programme the RESET button
An alarm code indicates a fault in the machinemust be pressed once or repeatedly to clear the
operation (see the relevant chapter on page 87).programme memory. This will be confirmed by three
dashes, flashing in the display.
If the previous programme is not cleared, the display
will show a ?0? flashing and an audible signal will
sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal
way.
76 |
ACEC
ZANUSSI
