Fig. 3Building-in
5
The housing dimensions should be as follows:
Height1446 mm
Minimum depth550 mm
Minimum width560 mm
Cooling air comes in through the ventilation grid at the
6
bottom of the appliance. To ensure air circulation,
leave a ventilation gap at the back of the appliance,
having the following dimensions:
D151
depth: 50 mm, width: 540 mm (Fig. 5).
Fitting door panels
A similar gap must also be left in the top of the kitchen
To Ţt the door panel, proceed as follows:furniture.
Loosen the screws Ţxing the side frame (Fig. 4);
Remove the two spacer bushes (A) then Ţt the appli-
loosen all the other screws Ţxing the door frame;ance into the recess in the tall kitchen unit. Using the
insert the panel from the side on which the frame hasfour screws supplied with the appliance, secure the
four corners of the appliance cabinet hinge to the tall
been removed and push it through;
kitchen unit.
reŢt the frame on the door again and tighten all the
screws.Fig. 5
50
Note:540
The panel size should be 1-2 mm lower than the door;
the maximum panel thickness should be 4 mm.
Fig. 4550
5601446
A
D152
D243
13 |
ACEC
CORBERO
