Water drainage
If the machine is permanently plumbed in, hook the
end of the drain hose into a standpipe installed for
3 pin
the purpose. The standpipe must have an internal
Joining piece
1
diameter of at least 40 mm (1 /2") in order that
40 mm
there is an air gap between the drain hose and theinside dia min
standpipe. Make sure, that it is designed in such a
way, that the end of the drain hose cannot be
600 mm min
covered with water.900 mm max
P0376
The drain hose may be extended to a maximum of
4 metres. An additional drain hose and joining
piece is available from your local service centre.
The joining piece must have an internal diameter of
18 mm.
Important
Before connecting up the machine to new pipework
or to pipework that has not been used for some
time, run off a reasonable amount of water to flush
out any debris that may have collected in the pipes.
When discharging into a standpipe ensure that the
end of the drain hose is neither too high nor too
low. The top of the curve in the hoseOs end should
be no more than 90 cm (35.4�), and no less than
60cm (23.6�) above floor level.
Levelling
Level the washing machine by raising or lowering
the feet. The feet may be tight to adjust as they
incorporate a self locking nut, but the machine
MUST be level.
Any necessary adjustment can be made with a
spanner. Accurate levelling prevents vibration, noise
and displacement of the machine during operation.
Some vibration is inevitable, especially if mountedP0850
on a wooden floor.
Sprung wooden floors are particularly susceptible
to vibration. For advice, consult a builder. If
possible, always place the machine on a solid floor.
Special conditions
If the floor is carpeted with a deep-pile carpet or
covered with crumbly or soft material, insert a rigid
support base under the feet to prevent noise,
vibration or displacement. The base should
protrude a few centimetres beyond the edges of the
Warning
The machine should NOT be placed
on deep pile carpeting.
8 |
ACEC
ZANUSSI
