CONSUMPTION DATAPROGRAMME CHANGEPROGRAMME END
Temperature LoadWaterEnergyEstimated Programme To reselect a programme when a cycle has already 1. At the end of the programme the programme
SelectorDurationstarted:selector moves to the stop position.
Programme2. To unload the washing machine wait for the
(°C)(kg)(l)(kWh)Min.1. Switch off the appliance by pressing the
?ON/OFF? button.door to unlock (about 2 minutes).
Cotton with prewash955.0802.001203. Switch off the washing machine, open the door
Cotton955.0701.801102. Select the new programme, temperature and and take out the laundry.
options.
Cotton605.0701.201104. Close the tap and leave the door ajar to allow
3. Start the programme by pressing the
Synthetics602.0600.9085?ON/OFF? button again.the drum to dry out.
Cotton short402.5650.7075
NOTES AND INDICATIONS FOR USE
Synthetics short402.5600.6075
Delicate401.5800.6070Water level
To obtain low water consumption without
Wool401.0800.6065
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized compromising washing results the water level
conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in within the drum may not be visible.
the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the energy
label refer to the programme Cotton 60°C.Cleaning the pump filter
A regular filter check and eventual cleaning is
ADD DETERGENTS, CLOSE THE DOOR AND SELECT ANY DESIDERED OPTIONadvisable.
SELECT THE PROGRAMME
?Half Load? button Motor smell
Add the detergents as described in the programme Washing machine motor creates a typical electrical
table or in the chapter ?Detergents and Additives? in Reduces water consumption, above all during
rinsing.smell during first cycles, this is normal and
the booklet.disappears after a few cycles.
1. Open the tap.Suitable for lightly-soiled laundry and small loads
(max 3 kg).
2. Set the programme selector to the desired
programme.?Rinse Hold? button
3. Set the temperature selector to the desired The laundry remains in the last rinse water
temperature.without progressing to the final spin cycle to avoid
4. Special options can be selected.creasing and prevent colours from changing.
5. Check that the door is well closed and turn on the This option is particularly recommended for the
washing machine by pressing the ?ON/OFF? programme ?Synthetic? or ?Delicate?.
This function is particularly useful if you want to
button. The indicator lights up, indicating that the
washing machine is on.postpone spinning to a later time, or if you want to
drain only.
Terminate the ?Rinse Hold? option:
Press the ?Rinse Hold? button again; the
programme will terminate automatically with the
final spin cycle for the present wash programme.
If you do not wish to spin the laundry, turn the
programme selector knob to the ?Drain?
programme.Whirlpool is a registered trademark of Whirlpool USA
5019 301 10220 |
ACEC
WHIRLPOOL
