Instructions to assemble the refrigeratorRemove the little plates and make the holes with a di-
door to the kitchen unit dooram. of 3,2 mm. Replace the little plates over the run-
ners and screw in the screws provided (3.5x16 mm).
Position the runners (C) at the top and bottom of theFor the alignment of the kitchen unit door, if neces-
inside of the kitchen unit as shown in Fig. 5 and marksary, use the clearance size of the slotted holes.
the position of the external holes.At the end of the procedure, check that the doors of
After preparing the holes, screw the runners to thethe appliance and the kitchen unit open properly.
kitchen unit door using 3.5x16 mm screws.
Fig. 7
Fig. 5
C
20mm
D416
D135
Reversibility of the freezer door (Fig. 8)
Open both the appliance door and that of the kitchen
unit to approx. 90°.When changing the hinges of the refrigerator door
Place the little plates over the runners. Hold the doorsfrom right to left, it is also advisable to change the
of the appliance and the unit together and mark theopening side of the freezer door.
holes.Please take the following steps:
Fig. 61. Remove the door lower hinge.
2. Remove the freezer door and take off the upper
8mmhinge.
3. Unscrew the catch and Ţx it on the opposite side.
4. Fix the upper hinge.
5. Mount the freezer door on the left side and Ţx the
lower hinge.
Fig. 8
D415
180!
15 |
ACEC
CORBERO
