124970993_FLE1015W.qxd 2/27/02 2:02 PM Pagina 7 (Nero/Process Black pellicola)
Operating
To select spin only, press the SKIP button twice.
The wash & rinse LED,s go out.
Sequence
Before the first wash, we recommend that you run a
cotton cycle at 60°C, without any laundry in the
machine, to remove any manufacturing residue from the
drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment of the dispenser drawer and start the
To select Drain, press the SKIP button three times, themachine.
wash - rinse - spin LED,s go out.
1.Load the laundry
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
If you wish to cancel or advance the running
programme to the required phase, PAUSE the cycle and
then press the SKIP button as previously described.
9 Programme phase indicator lights
When you select a programme, the lights relevant to the
phases that form the programme light up.2.Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment .
If you wish to carry out the prewash, pour detergent into
the appropriate compartment marked .
3.Measure out the fabric
softener
After you have started the programme, only the lightIf required, pour fabric softener into the compartment
relevant to the phase that is currently being carried outmarked , without exceeding the ?MAX? mark.
will remain lit.
At the end of the cycle the light will illuminate.
If at the end of the programme the light comes on, this
means that the drain filter must be cleaned (see page 16).
The END light flashes if there are operating
problems. At the same time one of the following lights
comes on indicating the type of problem:
: problem with the water supply
: problem with water drainingClose the drawer gently.
: door open
See paragraph ?Something Not Working?.
7 |