Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all the packaging for re-use in
case the machine is to be transported again.
Using a spanner unscrew and remove the rear right bolt.
Lay the machine gently on its back, making sure that the
hoses are not squashed.
P0255
Remove the polystyrene block from the bottom of the
machine.
2Carefully slide out the right polythene bag (1).
1
Repeat the operation for the left polythene bag (2).
P0234P0233
Remove the polystyrene base.
Set the machine upright and remove the two remaining
bolts from the back.
Pull out the three plastic spacers from the holes into
which the bolts were fitted.
P0256P0020Plug the open holes with the plugs which you can find
at the back of the appliance.
Positioning
Install the machine on a flat hard floor.The appliance has two inlet hoses, hot and cold, with
Make sure that air circulation around the machine is notfemale 3/4� BSP thread connectors. If this connection is
impeded by carpets, rugs etc. Check that the machinenot compatible with the plumbing of the existing
does not touch the wall or other kitchen units.installation, a variety of connectors are available from
Never place cardboard, wood or similar magood hardwterials underare stores and plumbers merchants to suit
the machine to compensate for any unevenness in themost domestic plumbing. Any alteration to your existing
floor.plumbing must be carried out by a competent person, or
qualified plumber.
Your new washing machine has been designed to be
permanently plumbed in to your homeOs water supply
and drainage system. However, if this is not possible, it
may be connected to suitable existing taps with the drain
hose discharging into a sink.
22 |
ACEC
ZANUSSI
