Installation
UnpackingPositioning
Install the machine on a flat hard floor.
All transit bolts and packing must be removedMake sure that air circulation around the machine is
before using the appliance.
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
You are advised to keep all transit devices so thatunits.
they can be refitted if the machine ever has to be
transported again.Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
1. Using a spanner, unscrew and remove the rear
materials under the machine to compensate for any
unevenness in the floor.ENGLISHright-hand bolt and lay the machine on its back,
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
P1051
P0255
Water inlet
2. Remove the polystyrene block from the bottom of
Connect the water inlet hose to a tap with a 3/4"
the machine and release the two plastic bags.thread after having inserted the small filter OA�
3. Carefully remove the right-hand bag (1) then the supplied with the machine.
left-hand bag (2) by pulling them towards theThe other end of the inlet hose which connects to the
centre of the machine.
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
2
1
A
P0234P0233
4. Set the machine upright and remove the two
remaining bolts from the back.P0003P0021
5. Pull out the three plastic spacers from the holesThe inlet hose must not be lengthened. If it is too
into which the bolts were fitted.short and you do not wish to move the tap, you will
6. Plug the open holes with the plugs which you willhave to purchase a new, longer hose specially
find at the back of the appliance.designed for this type of use.
P0256P0020
27 |
ACEC
ZANUSSI
