UX-1100DE
FO-1450DE
3. Assembly and connections4. Loading printing paper
1Plug the power cord into a 220-230 V, 50 Hz, grounded (2-prong)The paper tray holds the paper on which received documents and
outlet.copies are printed. Up to 300 sheets of A4 size paper from 60 to 90
2
g/cm can be loaded in the tray. For the best results, we recommend
Caution: Do not plug the power cord into any other kind of outlet.
that you use Sharp FO-16NC (A4 size) paper.
This will damage the machine and is not covered under
the warranty.1If the paper tray is in the fax machine, remove the cover. Grasp
the end of the paper tray, lift it slightly, and pull it out of the fax
machine.
AC outletAImportant:You must remove the paper tray from the fax ma-
chine to add paper.
2Insert one end of the telephone line cord into the "TEL. LINE"
jack. Insert the other end into a standard single-line telephone wall
socket.
2Push the pressure plate down until it locks into position.
Be sure to insert the telephone line cord into the "TEL. LINE"
socket. Do not insert it into the "TEL. SET" socket.
To
AC outlet
TEL.
SET TEL.
LINE
3Fan the paper and then place it in the paper tray, print side up.
Make sure the corners of the paper go under the holders, and
then shake the tray gently to straighten the paper.
Wall socket
3Attach the received document tray by inserting the tabs into the
holes at the rear of the fax.
1 � 6 |
ACEC
SHARP
