SHARP FO-5900DE Repair Manual

FO-5900SE
FO-5900DE
6. Wire treatment
Stamp cable must be passed through six ribs as
shown in fig.1.
Connect the stamp cable to CNSTP (2 pin) of con-
trol PWB
Front sensorDocument sensor
cable: Redcable:White
Transfer sensorScanner
cable:Yellow
frame unit
RibRibRib
Sensor cable
CIS cable
RibRib
Stamp cable
to Control PWB
(CNSTP) 2pinRib
Rib
Stamp (FO-45VS)
On account of the length of the stamp cable to the
control PWB, it is wired at shortest.
Fig. 1
7. Soft switch setting
When you install the verification stamp (FO-45VS),
set the soft SW 27. No. 3 initial setting to "1".
8. Replacing the verification stamp
If you are using the Verification Stamp function, you will need to
replace the ink cartridge in the stamp unit when it runs out of ink
(when the stamped mark on original documents becomes faint).3 Insert the new ink cartridge into the machine (make sure that
A new ink cartridge can be obtained from your dealer.the tab is facing out).
1 Remove the original document OUT tray.
4Replace the original document OUT tray.
2 Press down on the protruding tab of the green ink cartridge1
and pull the cartridge out with your fingers.
2
3
Stamp (Ink cartridge) only (20 pieces)
Parts code : UINK-2009SC01
3 � 28