cover and remove it. Always keep a rag nearby to dryTurn off the water tap. Unscrew the water inlet hose.
up spillage of water when removing the cover.Clean the filter using a hard bristle brush.
Tighten up the inlet hose.
?Remove any objects from the pump impeller by
rotating it.
The dangers of freezing
If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:
? Remove the plug from the socket.
? Close the water tap and unscrew the water inlet
hose from the tap.
? Place the end of the emergency emptying hose
and that of the inlet hose in a bowl placed on the
? Put the cap back on the emergency emptying hose andfloor and let water drain out.
place the latter back in its seat.? Screw the water inlet hose back on and reposition
the emergency emptying hose after having put the
cap on again.
By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.
When you use the machine again, make sure that
the ambient temperature is above 0°C.
Important!
? Screw the pump cover fully in.Every time you drain the water through the
? Close the pump door.emergency emptying hose you must pour 2 litres of
water into the main wash compartment of the
detergent drawer and then run the drain
Warningprogramme .To do this :
When the appliance is in use and depending on the
programme selected there can be hot water in the pump.? depress the ON/OFF button to switch the
Never remove the pump cover during a wash cycle,machine on;
always wait until the appliance has finished the cycle,? select a programme by means of the FABRICS button;
and is empty. When replacing the cover, ensure it is? depress RESET button three times;
securely retightened so as to stop leaks and young
children being able to remove it.? depress START/PAUSE button .
This will activate the ECO valve allowing a total use of
the detergent in the next wash.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
17 |
ACEC
ZANUSSI
