TROUBLESHOOTING
WARNINGIf a fault occurs, first check the points listed below before
taking the speakers for repair.
Under no circumstances should you try to repair
English
anything by yourself, as this will invalidate the
guarantee. Do not open the set as there is a risk ofIf you are unable to solve a problem by following these hints,
consult your dealer or service center.
electric shock.
PROBLEMPOSSIBLE CAUSESOLUTION
No sound VOLUME is not correctly adjusted.Adjust the VOLUME.
Headphones are connected.Disconnect headphones.
The wrong source is selected.Turn SOURCE SELECTOR to select the correct
source.
No sound on the One speaker is wrongly connected.Connect the speaker properly.
left or right side
A speaker cable is damaged.Replace the cable.
Volume balance in the receiver menu is Adjust VOL FR-L and VOL FR-R
wrongly adjusted.in the receiver menu.
Poor sound or no sound at SURROUND mode is not switched on.Press SURROUND ON/OFF to switch on the
the center or surround surround sound.
speakers
Surround and/or center speakers are notConnect the speakers properly.
(properly) connected.
Surround and/or center speakers are Set speaker present to YES.
switched off in the LS SETUP menu.
A speaker cable is damaged.Replace the cable.
Poor bass sound Speakers are not in phase.Connect the coloured (or marked) wires to the
coloured terminals and the black (or unmarked)
wires to the black terminals.
Bad soundBadly matching setting for the given type ofCorrect the sound settings on the receiver.
music or sound.
Surround sound level is The level of the surround sound is notAdjust the level of the surround sound on
too low or too high properly adjusted.the receiver.
Center sound level is too The sound level of the center channel is notAdjust the level of the center channel
low or too high properly adjusted.on the receiver.
Only center speaker is A mono signal is reproduced.Choose a different sound source or switch off
heard in Dolby Surround surround sound.
Pro Logic
Bad radio reception, Receiver or antenna is positioned near a Change the position of the interfering unit
automatic programming radiation source such as a TV, CD player, or try to switch it off.
does not work properlyCD recorder, DVD player, etc.
23 |