FS-SD1000(UB, US, UW, UY) / LVT0685-002A / English
FS-SD1000_01E.book Page 13 Wednesday, May 9, 2001 10:30 AM
Using the Tuner
l Preset Tuning using the Unit
6Repeat above steps 1 to 5 for each sta-
Press the PRESET TUNING + or - button to select
the desired preset number. tion you want to store in memory with a
Its band and frequency are displayed.preset number.English
To change the preset stations repe,at the same
steps as above.
? In AM broadcast, reception sensitivity will be changed by
turning the AM loop antenna. Turn the AM loop antenna Auto Presetting
for best reception.
In each band, you can automatically preset FM-30, AM -15
stations. Preset numbers will be allocated as stations are
found, starting from the lowest frequency and moving up
Presetting Stations
the frequency.
AUTO
You can preset up to 30 FM stations and up to 15 AM sta-PRESET
(for 2 seconds)
tions using the Remote Control.FM / AM
? Preset numbers may have been set to factory test fre-
1Select a band by pressing the FM/AM
quencies prior to shipment. This is not a malfunction. You
button.
can preset the stations you want into memory by following
one of the presetting methods below.2Press the AUTO PRESET button on the
Remote Control for more than two sec-
onds.
Manual Presetting
SETSTORED3Repeat steps 1-2 for the other band.
FM / AMn If you want to change the preset stations, carry out the SETUPDOWNSET
orManual Presetting for the desired preset numbers.
When changing the BandFM = 30, AM = 15
CAUTION:
1Select a band by pressing the FM/AM ? Even if the system is unplugged or if the
button.power failure occurs, the preset stations
will be stored for about 24 hours. However,
2Press the4 or c button to tune in a in case the preset stations are erased, you
station.will need to preset the stations again.
3Press the SET button.
?SET? will blink for 5 seconds.To Change the FM
Within 5 seconds, proceed to the next step.
Reception Mode
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
When you are tuned into an FM stereo broadcast, the
4Press the UP, DOWN, >, or < button ?STEREO? indicator lights up and you can hear stereo ef-
fects.
within 5 seconds to select the preset
If an FM stereo broadcast is hard to receive or noisy, you
number.
can select Monaural mode. Reception improves, but you
UP or DOWN button:Increase or decrease the losepreset stereo effect.
number by 1.
Pressing and holding the buttonPress the FM MODE button on the Remote Control
will continuously increase or so that the de-?MONO? indicator lights up on the dis-
crease the preset number.play.
FM MODE
> or < button:Increase or decrease the preset
MONO
number by 1.
Pressing and holding the button
will rapidly increase or decrease
the preset number.
To restore the stereo e presffects the FM, MODE button
on the Remote Control so that the ?MONO? indicator goes off.
5Press the SET button within 5 seconds.
?STORED? appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
13 |
ACEC
JVC
