FS-X1(UJ)_E.book Page 14 Tuesday, May 20, 2003 3:20 PM
Using the Tuner
Preset Tuning using the Remote Control
(Possible only after presetting stations)4Press the Numeric Keys, or the 3 or 2
Select the desired preset number using the 3 or 2button within 5 seconds to select the
button on the Remote Control. The display will showpreset number.
the preset number?s band and frequency.
Example:
You can also select the desired preset number
using the Numeric Keys. See ?Entering the
Number with the Remote Control? on page 12.
(e.g. Press +10, and then 2 for number 12.)
Example:
Press the 3 button until the preset number ?2? ap-
pears.
Preset number
UPDOWN
3Press the SET button within 5 seconds.
35
or?STORED? appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
Presetting Stations
preset number.
To change the preset stations, repeat the same
You can preset up to 30 FM stations and up to 15 AM sta-
steps as above.
tions.
CAUTION:
Even if the system is unplugged or if the
Preset numbers may have been set to factory test fre-power failure occurs, the preset stations
quencies prior to shipment. This is not a malfunction. You will be stored for about 24 hours. However,
can preset the stations you want into memory by following in case the preset stations are erased, you
one of the presetting methods below.will need to preset the stations again.
To Change the FM Reception
1STORED
FM / AMMode
SET+102SET
orWhen you are tuned into an FM stereo broadcast, the ?ST.?
indicator lights up and you can hear stereo effects.
FM = 30, AM = 15If an FM stereo broadcast is hard to receive or noisy, you
When changing the Bandcan select Monaural mode. Reception improves, but you
lose stereo effect.
FM AUTO mode is also useful to suppress static noise be-
On the Remote Controltween stations.
1Select a band by pressing the FM/AM To enter Monaural mode while receiving an FM
broadcast, press the FM/PLAY MODE button on the Re-
button.
mote Control until ?FM MONO? appears on the display. Then,
the ?MONO? indicator lights up.
2Press the 5 or button to tune in a sta-
Each time you press the FM/PLAY MODE button, the display
tion.alternates between ?FM AUTO? and ?FM MONO?.
3Press the SET button.
FM/PLAY
MODE
Preset number ?1? will blink for 5 seconds.
Within 5 seconds, proceed to the next step.FM AUTO � FM MONO
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
To restore the stereo effect, press the FM/PLAY
MODE button on the Remote Control until ?FM AUTO? ap-
pears on the display. Then, the ?MONO? indicator goes out
and the ?ST.? indicator will light up.
14 |
ACEC
JVC
