1879-2
USING SUNRISE & SUNSET MODEAUTO DISPLAY FUNCTION
A few seconds after pressing CCCCC twice in the Time-The Auto Display function of this watch continually changes the contents of the display.
keeping Mode, the display will move to the SunriseNote that you cannot use any of the watchOs other functions while the Auto Display
& Sunset Mode. The display shows sunrise time,Moon phasefunction is operating.
moon age, and moon phase for the date indicated
in the time mode. When sunrise, sunset, and moonTo turn the Auto Display on
age data for other dates is required, press AAAAA or DDDDDHold down CCCCC for about two or three seconds in any mode until the watch beeps.
in this mode to obtain the required date. Hold down
for rapid advance. When required date has beenTo turn the Auto Display off
Sunrise
set, the display will show sunrise, sunset, and moontimeHold down CCCCC for about two or three seconds until the watch beeps. At this time the
age data for this date after approx. 20 seconds.
watch is in the Timekeeping Mode.
Precaution for Sunrise & Sunset ModeNote
Moon age
? The sunrise or sunset time is that of the surfaceThe Auto Display function cannot be performed while you are making settings (i.e.
Sunset timeat 0 meter sea level. (So, it is not able that thewhile digits or other setting are flashing on the display).
sunrise or sunset time displayed may include an
error depending on where you are.)
? Minimum display unit is: approx. ?5 minutes where is at less than 50° in latitude and
approx. ?10 minutes at 50° or more in latitude.
? Sunrise & sunset time is indicated by 5 minutes unit.
USING DAILY ALARM
The alarm beeper will sound for 20 seconds everyday the
preset time until cleared when daily alarm is set. Press
any button to stop beeper.
A signal will sound every hour on the hour if time signal is
set.
Sound demonstration
Press and hold AAAAA in Alarm Mode to sound beeper.
1)Press BBBBB in the Alarm Mode to set new alarm time.
2)Each press of CCCCC shifts the flashing position.
HourMinutes3)Pressing AAAAA increase digit by one. Hold down for rapid
advance.
4)Press BBBBB to complete.
Display automatically returns to initial Alarm Mode dis-
play if left unused for a few minutes.
On or off setting of alarm and time signal
In the Alarm Mode, each push of DDDDD button will change alarm ON/OFF as follows.
appears when alarm is ON.
appears when time signal is ON.
USING STOPWATCH
SPLIT/RESET
Mode indicator
START/STOP
Hour1/100 second
Minutes
Seconds
A signal confirms each button operation.
Working range
Total elapsed time display is limited to 23 hours 59 minutes 59.99 seconds.
Thereafter it will be automatically reset and started again.
Net time measurement
(Time loss)
StartStopRe-startStopReset
Split time measurement
StartSplitSplit releaseStopReset
1st-2nd place times
StartSplitStopSplit releaseReset
The first runnerThe second runnerRecord the time of
finishes.finishes.the second runner.
Record the time of
the first runner.
Tips�
?Various moon time information for a specification can
be calculated by inputting of longitude, latitude and time
difference from GMT. Therefore correct entries are nec-
essary.
For world time zones, see the time zone chart booklet
attached.
?When summer time adjustment is made, donOt forget to
adjust time difference from GMT.
?When location is changed, new location data should be
inputted to get correct moon time information.
?When the watch shows wrong moon time information
compared with actual observed values, or estimated
values by public authorities, check entries in the follow-
ing order: year setting, time difference from GMT, LON-
GITUDE, LATITUDE, EAST OR WEST, NORTH OR
SOUTH. |
ACEC
CASIO
