FU-40SE-K
3. Removing the display PWB, the dustUnscrew the switch PWB support to remove it.
sensor and the switch PWBSwitch PWB harness
CAUTION:
LED support can not be removed from displaySwitch PWB guide
PWB (Because there is LED of Cluster ion lamp.)
LED supportLED of Cluster ion lamp
Display PWBLED sticker
Switch PWB
Screw
Make harness processing in assembling as mentioned
in the figure. Confirm whether the movement of the
power supply button is smooth after assembling.Connector FConnector H
4. Removing the relay PWB
(1) Pull out the connectors H and J. Unscrew the
relay PWB to remove it.
Spacer A(1)Remove the screws (2 pcs.) fixing th display PWB.
(2) Pull out the connector F and remove the dust
sensor.
Connector EConnector F
Connector JRelay PWB
5. Removing the fan
(1) Loosen the nut and remove the fan washer, the
rubber washer, the fan washer, the fan, the fan
washer T2 and the washer.
Screw Connector H Screw(2) The tie torque of the nut is 1.5 Nm.
(3) Apply the screw lock (Three Bond 1401B) to the
shaft and tighten the nut. To reduce the fan face
(3) Pull out the connector G and remove the screw.runout, never touch the periphery of the fan when
Switch PWB harnesstightening the nut.
The line processing at the Nut
Special washertime of an assembly should
let the bottom of rib pass.Medium
Fan washer
Rubber washer
Fan
SmallWasher
LargeFan washer T2
Connector GScrew
23 |
ACEC
SHARP
