FU-425E
SAFETY PRECAUTIONS
When using electrical appliances, basic safety precautions should be followed, including the
following:
WARNING - To reduce the risk of electrical shock, fire or injury to persons:
YRead all instructions before using the air purifier.
YUse only a 220-240 volt outlet.
YDo not use the air purifier if the power cord or plug is damaged or the connection to the wall outlet is loose.
YPeriodically remove dust from the power plug.
YDo not insert fingers or foreign objects into the intake or air outlet.
YWhen removing the power plug, always hold the plug and never pull the cord.
Electrical shock and/or fire from short circuit may occur as result.
YDo not use this air purifier near gas appliances or fireplaces.
YRemove the power plug from the wall outlet before cleaning the unit and when not using the unit.
Electrical shock from bad insulation and / or fire from short circuit may occur as a result.
YIf the power cord is damaged, it must be replaced by the manufacturer, its service agent, Sharp authorized
servicers or similarly qualified persons in order to avoid a hazard.
YDo not operate when using aerosol insecticides or in rooms where there is oily residue, incense, sparks from lit
cigarettes, chemical fumes in the air or in very high humidity condition such as a bathroom.
YUse care when cleaning the air purifier. Strong corrosive cleansers may damage the exterior.
YOnly Sharp Authorized Servicers should service this air purifier. Contact the nearest Servicer for any problems,
adjustments, or repairs.
YThe batteries must be removed from the remote control before disposal, and the batteries must be disposed of safely.
CAUTIONS CONCERNING OPERATION
YDo not block the intake and air outlet.
YDo not use the unit near or on hot objects, such as range or where it may come into contact with steam.
YAlways hold the handle on the back of the main unit when moving it.
Holding the front panel when carrying may cause it to detach, thus dropping the unit and resulting in bodily injury.
YDo not operate the unit without the filter.
Not only it does not improve filter performance, it may cause electric shock or malfunction.
YClean the exterior with a soft cloth only.
The unit surface may be damaged or cracked.
In addition, the sensor may malfunction as a result.
INSTALLATION GUIDELINES
YDuring the operation of the product, please place the unit at least 2m away from equipmentswhich involve
electric wave such as televisions, radios or wave clocks, in case electricalinterference occurs to such
equipments.
YAvoid a location where the sensor is exposed to direct wind.
The unit may not operate properly.
YAvoid locations where curtains, etc., come into contact with the intake or air outlet.
Curtains, etc., may become dirty or a malfunction may occur.
YAvoid locations where the unit is exposed to condensation, due to drastic temperature changes.
YPlace on a stable surface with sufficient air circulation.
YDo not install when there is generation of lampblack, such as in a kitchen, etc.
The unit surface may crack or the sensor may malfunction as a result.
FILTER GUIDELINES
YFollow the instructions in this manual for correct care and maintenance of the filters.
2 |
ACEC
SHARP
