FU-60SE-S
CARE AND MAINTENANCE
MAIN UNITDUST SENSOR
ODOR SENSOR
For soiling on the main unit and
the installed floor / table surface,
The care cycles of ODOR SENSOR and DUST
clean as early as possible. Stub-SENSOR are once three months.
born dirt may be hard to remove.The sensitivity of the sensors will become unstable
if the odor or dust sensor is dirty or blocked. Please
Dry wipe with a soft cloth
clean these parts as follows.
For stubborn dirt, wipe with a
soft cloth dampened with waterDUST SENSOR
or warm water of 40uC or less.
Remove the front
Do not use volatile fluids1panel and detach the
Benzene, paint thinner, polish-sensor filter
ing powder, etc., may damageDetach the sensor filter
the unit surface.
while pulling the tab on
Do not use detergentsthe sensor cover.Sensor cover
Detergent ingredients may dam-Remove dust fromSensor filter
age the unit surface.2sensor filter.
Detach the sensor fil-
Do not get wet
ter, and tap it lightly
Never apply water on the unit.
with your hand to re-
move the dust.
If it is very dirty, wash it
with water and then al-
FILTERlow it to dry thoroughly.
CLEANINGInsert the sensor fil-
3ter into the cover, in-
Clean the top surface of the pre-stall it in the main
filter lightly with a vacuumunit and attach the
cleaner.front panel.
The sensor filter can bePre-filter
inserted either way
round.
CAUTIONSensor cover
Do not forget to reinstall the sensor cover before
restarting the unit.
Do not insert foreign object (toothpick, etc,)
NOTEinto the filter. This may result in damage or mal-
functioning of the unit.
The HEPA filter is damagedSensor
easily. Do not bring it into di-opening
rect contact with the nozzle ofODOR SENSOR
a vacuum cleaner.Remove dust from the sur-
Also make sure never to washface of the sensor opening
it with water.with a vacuum cleaner.
The HEPA filter and Active
carbon filter do not need clean-
ing.
9 |
ACEC
SHARP
