HDTV functions (with optional BKFV-100Image enhancerHorizontal and vertical aparture
installed)correction with crispening, level
System1080/60Idepend, horizontal and vertical
1080/59.94IMaster and detail gain control
1080/50IFrame storefor reference frame
1080/24PsF16 frame @ SD 8:8:8
1080/23.976PsFWipeHorizontal and vertical wipe
Electrical zoomArea magnification: 0.5´ to 4´Source selection: main, input, frame
by Zoom or independent X and Ystore
4)
sizing with pan and tilt affecting SDSignal to noise ratio for luminance better than 62 dB
(625/525) pictureVideo inputD-1 SDI (4:2:2) - max. 3 channels or
Blanking controlIndependent X and Y adjustingdual D-1 SDI (4:2:2:4 or 4:4:4:4 or
Image enhancerHorizontal and vertical aparture8:4:4)
correction with crispening, levelVideo outputD-1 SDI (4:2:2) or dual D-1 SDI
depend, horizontal and vertical peak(4:4:4, 8:4:4)
frequency, and detail gain controlMonitor out (analog composite)
Frame storefor reference frameSequence outputPulldown sequence pulse
4 frame @ HD 4:4:4
WipeHorizontal and vertical wipeReference Input/Output (Analog)
Source selection: main, input, frameHD Input/OutputTrilevel sync
storefield rate: 60/59.94
3)
Signal to noise ratio for luminance better than 58 dB50/49.95
Video inputHD SDI (4:2:2)48/47.952
Video outputHD SDI (4:2:2)SD Input/OutputBlack burst (NTSC/PAL)
Sequence outputPulldown sequence pulse525 sync
625 sync
SDTV Functions
The FVS-1000 system is furnished with one channel of SDIRemote interface
processing board. A second channel can be configured byRS-422Telecine controller I/F D-sub 9-pin
adding the BKFV-200 SDTV processing board.
System525/625 switchableDesigns and specifications are subject to change
Electrical zoomArea magnification: 0.25´ to 4´without notice.
by Zoom or independent X and Y
sizing with pan and tilt including
Crop, Squeeze and Letter box
Blanking controlIndependent X and Y adjusting
...........................................................................................................................................................................................................
3) Measured at 50% video level, gamma = 0.4.4) Measured at 50% video level, gamma = 0.4.
The ratio being 700 mV divided by r.m.s noise voltageThe ratio being 700 mV divided by r.m.s noise voltage
At the below conditions:At the below conditions:
Film type:IPFilm type:IP
Imager gain:M:0, R, G, and B; A000Imager gain:M:0, R, G, and B; A000
Iris:0000Iris:0000
Film Gamma: 5Film Gamma: 5
Detail gain:0000Detail gain:0000
Back level:Setting all 0000 and after adjustBack level:Setting all 0000 and after adjust
350 mV by Master level350 mV by Master level
29 |
ACEC
SONY
