Electrical connectionThe wire coloured blue must be connected to the
terminal marked ?N? or coloured black.
Any electrical work required to install this appliance
The wire coloured brown must be connected to the
should be carried out by a qualified electrician or
terminal marked ?L? or coloured red.
competent person.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
WARNING: THIS APPLIANCE MUST BE
the outer sheath.
EARTHED.
The manufacturer declines any liability should
WARNING:
this safety measure not be observed.
A cut off plug inserted into a 13 amp socket is
Before switching on, make sure the electricity supplya serious safety (shock) hazard.
voltage is the same as that indicated on the appliance?sEnsure that the cut off plug is disposed of
rating plate. The rating plate is located at the top of thesafely. Should the appliance power supply
rim of the open door.cable need to be replaced, this must be carried
out by our Service Centre.
Note
When the appliance is installed the power supply cable
must be accessible.
Permanent connection
- In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
The appliance is supplied with a 13amp plug fitted.
of 3mm between the switch contacts and of a type
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved (BS1363) fuse mustsuitable for the required load in compliance with the
current electrical regulations.
be used.
Should the plug need to be replaced for any reason,The switch must not break the yellow and green earth
proceed as described below.cable at any point.
The wires in the mains lead are coloured in accordance
with the following code:
Green and Yellow- Earth
Blue- Neutral
Brown- Live
&'(( )*(++,-
-
',-
+1(
.,'/ .+0
The wire coloured green and yellow must be connected
to the terminal marked with the letter ?E? or by the
earth symbol or coloured green and yellow.
28 |