132990360GB.qxd 21/01/2004 10:51 Pagina 64
The other end of the inlet hose which connects toAny extension applied to the drainage hose should
the machine can be turned in any direction. Simplynot be longer than 200 cm and its diameter must not
loosen the fitting, rotate the hose and retighten thebe smaller than that of the original hose. Use a
fitting, making sure there are no water leaks.suitable fitting for the connection.
The drain hose must not be kinked.
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose speciallyFor a correct functioning of the machine the
designed for this type of use.drain hose must remain hooked on the proper
support piece situated on the top part of the back
side of the appliance.
Water drainage
The end of the drain hose can be positioned in three
ways:Electrical connection
Hooked over the edge of a sink using the plasticThis machine is designed to operate on a 220-230 V,
ENGLISHhose guide supplied with the machine. In thissingle-phase, 50 Hz supply.
case, make sure the end cannot come unhookedCheck that your domestic electrical installation can
when the machine is emptying.take the maximum load required (2.2 kW), also
This could be done by tying it to the tap with a piecetaking into account any other appliances in use.
of string or attaching it to the wall.Connect the machine to an earthed socket.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution.
Should the appliance power supply cable
need to be replaced, this should be carried
out by our Service Centre.
Please ensure that when the appliance is
In a sink drain pipe branch. This branch must beinstalled the power supply cable is easily
above the trap so that the bend is at least 60 cmaccessible.
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
64 |
ACEC
ZANUSSI
