2161/2251/2261-2
COUNTDOWN ALARM MODESTOPWATCH MODE
Current timeThe countdown timer can be set within a range of 1 sec-Current timeThe Stopwatch Mode lets you measure elapsed time, split
ond to 24 hours. When the countdown reaches zero, anMode indicatortimes, and two finishes. The range of the stopwatch is 23
Mode indicator
alarm sounds for 10 seconds or until you press any but-hours, 59 minutes, 59.99 seconds.
ton.
To measure elapsed time
To set the countdown time1.Press BBBBB to start the stopwatch.
1.Press AAAAA while in the Countdown Alarm Mode. The hours2.Press BBBBB to stop the stopwatch.
digit flashes on the display because it is selected.?You can resume the measurement operation by press-
2.Press CCCCC to change the selection in the following se-ing BBBBB again.
quence.3.Press AAAAA to clear the stopwatch to all zeros.
?For the first 60 minutes, the display shows minutes, sec-
Minutes
HoursSecondsHoursMinutesSecondsonds, and 1/100 second. After 60 minutes, the display
format changes to show hours, minutes, and seconds.
MinutesSeconds
3.Press BBBBB to increase the selected number. Holding down BBBBB changes the number1/100 second
at high speed.
?To set the starting value of the countdown time to 24 hours, set to 0:00' 00.
To record split times
4.After you set the countdown time, press AAAAA to return to the Countdown Alarm Mode.1.Press BBBBB to start the stopwatch.
?If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Countdown Alarm Mode automatical-2.Press AAAAA to display the timing up to that point. Stopwatch timing continues internal-
ly.
ly.3.Press AAAAA to clear the split time and to continue time measurement on the display.
?You can repeat steps 2 and 3 as many times as you want.
To use the countdown timer4.Press BBBBB to stop the time measurement.
1.Press BBBBB while in the Countdown Alarm Mode to start the countdown timer.5.Press AAAAA to clear the stopwatch to all zeros.
2.Press BBBBB again to stop the countdown timer.
?You can continue countdown timer operation by pressing BBBBB.To time first and second place finishes
3.Stop the timer and then press AAAAA until the countdown time is reset to its starting
1.Press BBBBB to start the stopwatch.
value.2.Press AAAAA when the first finisher crosses the line, and record the time.
?When the end of the countdown is reached and auto repeat timing is off, the alarm
sounds for 10 seconds or until you stop the alarm by pressing any button. Count-3.Press BBBBB when the second finisher crosses the line.
4.Press AAAAA to display the finishing time of the second finisher.
down timing stops, and the countdown time is automatically reset to its starting5.Press AAAAA again to clear the stopwatch to all zeros.
value after the alarm stops.
To switch auto repeat timing on and off
1.Press AAAAA while in the Countdown Alarm Mode. The hours
digit flashes on the display because it is selected.
2.Press DDDDD to switch auto repeat on and off.
3.Press AAAAA to return to the Countdown Alarm Mode.
?When the end of the countdown is reached while auto
repeat is on, the alarm sounds, but the starting count-
down time is reset and countdown timing starts again
automatically whenever the countdown reaches zero.
Auto repeat on indicatorYou can stop timing by pressing BBBBB, and manually reset
to the starting countdown time by pressing AAAAA. |
ACEC
CASIO
