Remove the canopy to gain access to the Bezel or (Goal post trim) securing screws. The canopy is held in position by
dimpled spring clips on both the side flanges, remove by exerting an even pull forward, see below.
Remove the outer bezel/Goal post trim by unscrewing the four M4 taptite screws on the inner flanges and the four No 8 self
tapping screws in the corners.
It will be necessary to dismantle the burner from the convector box before installing the box in the opening, to remove the
burner, unscrew the two screws securing the L & R hand side cheeks in position, remove the coal support shelf, burner
inserts, back panel and the side cheeks. Unscrew the two screws at the base of the aperture in the fascia panel and withdraw
the burner observing that the rear feet locate under two tabs in the base plate.
- 8 -
Installing the Appliance in Position |
ACEC
CROSSLEE
