1IroningTU
V
T Steam activator
U Iron power-on button with light
V Blowing/suction button
D Air vent slide
I Height adjustment leverJHID
H Board tilting button
J Locking strap
M Mains plug
E Ironing tips and tricks
? To iron shirts, use the wide end of the board to save time
and energy. M
? To avoid shine and seam imprints, use the blowing mode.
? To hold the garment at on the board, use the suction mode.
1Put the mains plug M in an earthed 5If you want to iron with steam, set the
wall socket. The power-on light goes temperature dial of the iron to 2 or
on.higher and press the steam activator T.
Fill the water tank.Never direct the steam
at people.
2Undo the locking strap J and unfold 6If you want to iron in the blowing
the ironing board to vertical position.mode, press the rounded side of the
blowing/suction button.
Set both air vent slides D to the If you want to iron in the suction
ironing position.mode, press the hollow side of the
blowing/suction button.
3Push the board tilting button H and 7You can safely put down the hot iron
tilt the board to horizontal position.on the board cover during ironing.
Set the ironing board to the
appropriate height by means of the
height adjustment lever I.
4Take the iron out of the iron 8You can store the hot iron in the
compartment, either from the left or heat-resistant storage compartment
right side.immediately after you have switched
Switch the iron on by pressing the iron the iron off.
power-on button U. The power-on
light goes on.
After approx. 2 minutes the iron
is ready for use. |
ACEC
PHILIPS
