Getting StartedGetting Started
Automatically Adjusting the SizeStep 2: Connect the power cord
With the monitor switched off, connect one end of theand Centering of the Picture
power cord to the monitor and the other end to a power
By pressing the auto sizing and centering (ASC) button, theoutlet.
size and centering of the picture are automatically adjusted
to fit the screen.
to a power outletto AC IN
1Turn on the monitor and computer.
Power cord (supplied)2Press the ASC button.
The picture is adjusted to fit the center of the screen.
ASC
Step 3: Turn on the monitor and computer
The installation of your monitor is complete.
Note
If OOUT OF SCAN RANGE� or ONO INPUT SIGNAL� appears on
the screen, see OWarning Messages� on page 20.
Notes
ENFor customers using Windows 95/98Y This function is intended for use with a computer running
To maximize the potential of your monitor, install the new modelWindows or similar graphic user interface software that
information file from the supplied Windows Monitor Informationprovides a full-screen picture. It may not work properly if the
Disk onto your PC.background color is dark or if the input picture does not fill the
This monitor complies with the OVESA DDC� Plug & Playscreen to the edges (such as an MS-DOS prompt).
standard. If your PC/graphics board complies with DDC, selectY The screen may go blank for a few seconds while performing the
OPlug & Play Monitor (VESA DDC)� or this monitorOs model nameauto-sizing function. This is not a malfunction.
as the monitor type in the OControl Panel� of Windows 95/98. IfY Although the signals for picture aspect ratio 5:4 (resolution: 1280
your PC/graphics board has difficulty communicating with this´ 1024) do not fill the screen to the edges, the picture is
monitor, load the Windows Monitor Information Disk and selectaccurately displayed.
this monitorOs model name as the monitor type.
For customers using Windows NT4.0
Monitor setup in Windows NT4.0 is different from Windows 95/98
Selecting the On-screen Display
and does not involve the selection of monitor type. Refer to the
Windows NT4.0 instruction manual for further details on adjustingLanguage
the resolution, refresh rate, and number of colors.
If you need to change the OSD language, see OUsing the
LANG (Language) On-screen Display� on page 17.
The default setting is English.
7 |
ACEC
SONY
