ROLAND GK-3B Instruction Manual

GK-3B_e.book 11 Z
8
?
?
?
??
?e
?
?xý~
Uxý9=
?p
?
? 
Attaching the GK-3B to the Bass
5.Remove the backing from the tapes for * Use care in handling the divided pickup; bending or
the pickup cushion, the pickup twisting it may cause breaking in the coil elements.
Carefully insert something thin and flat (like a table
spacers, and the pickup, and carefully
attach the pickup to the bass.knife) under the Pickup from the bottom string side,
then gently pry the pickup upwards.
* After affixing these items, press them so that the
items adhere firmly.fig.1120 (Removing the Pickup)
* Wipe off any dust that may be on the location to
which you're affixing the double-sided tape. If the
location is dusty or dirty, the double-sided tape may
not adhere sufficiently.
6.Restring and tune the bass, then
carefully check the height of the
divided pickup once more.
Measure with the clearance gauge to4) After removing the pickup, carefully
confirm that the clearances between theremove the double�sided tape from
pickup and the strings are approximatelythe bottom of the pickup.
1.5 mm (0.06�) when you press the top5) Adjust the height of the Pickup.
and bottom strings at the highest fret,
If you wish to add a spacer, first
then finish up by making sure that thecompletely remove the used double�
strings do not touch the pickup when you
sided tape from the top surface of
play the bass.
Then attach the cord hook near thethe existing spacers, then add the
new spacer.
bridge, and fasten the pickup cable in the
hook so that it does not lift up or touchIf you need to remove any spacers,
remove the necessary number of
the strings.
fig.1115espacers and completely remove the
remaining double�sided tape from
the top surface.
6) Attach a piece of the new double�sided
tape B to the bottom of the pickup.
fig.1130
Cord Hook
7.Take the steps below if the height of
the divided pickup is not right.
1) Carefully examine the pickup in its
current state, and add a suitable
number of spacers if the pickup is
too low, or remove one or more7) Attach the pickup to the top of the
spacers if the pickup is too high.spacer that is applied to the bass side.
2) Remove the strings from the bass.8) Restring and tune the bass, then
3) Remove the divided pickup from thecheck the height of the Divided
bass.Pickup again.
11